| TURNUT |  |
| Available in M4/M5/M6/M8 Machine Screw Features Easy installation and no special tool required Nut provides a large bearing surface Low profile flange For thin sheet metal from 0.5 to 3.0mm in thickness (from 0.5 to 6.0mm with TN-6S, TN-8) |
Installation Step
 |
 |
 |
| After inserting TURNUT into pre-hole, position an article and push screw in lightly.Then nut turns. | Turn screw anticlockwise a little, pushing
screwforward with hand driver. Then drive it in. |
Continue to drive it until it is fastened tightly. |
Size/Material
| Material: Zinc Die-Casting (nut part) Stainless Steel AISI 304 (flange) |
 |
| Item Number |
Bolt Size |
Length of Screws |
Pre-hole Diameter | Length L1 |
Length of the nut L2 |
Frangre H |
Breaking Torque N・m(lb・in) |
Max Tension Load KN (lb) |
|
| Press | Drill Bit | ||||||||
| TN4 | M4 | 13+A | 8.0mm | 5/16" | 17.5mm | 14.0mm | 10.0mm | 4.9 (43.4lb・in) | 2.5 (562lb) |
| TN5 | M5 | 14+A | 9.0mm | 23/64" | 19.5mm | 15.5mm | 11.0mm | 5.9 (52.1lb・in) | 3.4 (757lb) |
| TN6 | M6 | 16+A | 10.0mm | 25/64" | 23.0mm | 19mm | 12.0mm | 9.8 (86.8lb・in) | 4.9 (1,103lb) |
| TN6S | M6 | 20+A | 12.5mm | 31/64" | 27.5mm | 21mm | 15.0mm | 19.6 (173.6lb・in) | 7.8 (1,764lb) |
| TN8 | M8 | 20+A | 12.5mm | 1/2" | 27.5mm | 21mm | 15.0mm | 17.7 (156.7lb・in) | 6.4 (1,433lb) |
Warning
Nut is Zinc Die Cast. Do not overtorque.
Breaking torque listed is maximum.
Do not exceed these values.They are for reference
only.
